HoMedics BPW-101 - Manual (Page 9)

16 15
Press the button
blinking month
increasing month
confirm the entry
repeat process to set date and time
DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the Set
button . The display will show a
blinking number showing the month.
2. Change the month by pressing the
button. Each press will increase the num-
ber by one in a cycling manner. Press the
Set button
again to confirm the entry,
and the screen will show a blinking num-
ber representing the day of the month.
3. Change the date and time as described
in Step 2 above, using the button to
change the numbers and the Set button
to confirm the entries.
4. A “0” will reappear as the blood pressure
monitor is ready for measurement again.
APPLYING THE CUFF
1. Remove all watches,
wrist jewelry, etc. prior
to attaching the wrist
monitor. Clothing
sleeves should be rolled
up and the cuff should
be wrapped around
bare skin for correct
measurements.
2. Apply cuff to left wrist
with palm facing up as
shown in Fig. A.
3. Make sure the edge
of the cuff is about
1/4”~1/2” (1 cm) from
the palm as shown
in Fig. B.
Fig. A
Fig. B
BPW-101IB_ENGSP.qxd 10/24/05 11:14 AM Page 15