HONDA FS7054 - Manual (Page 22)

MAINTENANCE & ADJUSTMENTS
BROOM REPLACEMENT
Whenever the broom becomes excessively tapered,
worn past the service limit or sweeping is difficult,
replacement is necessary.
SERVICE LI M IT
1/2 inch
Broom Removal
1. Make sure the engine is turned off, the ignition key is removed, and the spark plug cap(s) are
2. Use the sweeper lift crank to raise the broom until it is just slightly off the ground.
3. Remove the drive chain retaining clip, and remove the master link from the drive chain. The retaining
disconnected.
clip can get bent or damaged during removal, so never reuse the clip. Always install a new master link
during assembly.
4. Unbolt the two pillow block bearings from the sweeper hood by removing the four 3/8-16 inch carriage
bolts.
5. Use the sweeper lift crank to raise the sweeper hood above the broom assembly. Roll the broom
assembly out from under the sweeper hood.
3/8-16" CARRIAGE
BOLT
(4)
3/8" NUT (4)
FS7054 SWEEPER
21