HONDA FS7054 - Manual (Page 20)

MAINTENANCE & ADJUSTMENTS
Drive Chain Slack
Loosen the bolt securing the adjustment roller so
the roller is free to drop down. The chain should
have approximately 1/2-inch of slack at the location
shown. After adjustment, tighten bolt securely.
Premature chain, roller and sprocket wear will result
if the chain is run without enough slack.
If the chain slack cannot be adjusted with the roller
all the way down, remove the 1/2-link and re-check
slack. Always install a new master link with the
retaining clip positioned as shown.
If proper chain slack cannot be achieved with the
1/2-link removed and the roller all the way down,
replace the chain.
Gear Box
Put the sweeper on a level surface.
1. Remove the two wing nuts and left access cover.
2. Use a 114 inch allen wrench and remove the oil
3. The oil should flow out the plug hole. If not, fill
4. Install the oil check plug and tighten it securely.
5. Install the access cover.
check plug.
with the recommended oil.
Recommended oil: GL-4 or GL-5 80w90 gear oil
Deck Belt
Refer to the mid-size commercial mower owner's
manual or shop manual for additional details and
illustrations.
Removal
1. Move the blade control to the OFF position.
2. Angle the sweeper 25
o
left.
3. Remove the right access cover.
4. Angle the sweeper 25 o right.
5. Remove the left access cover.
6. Loosen the belt-guide bolts on the power unit.
These are accessible from the top of the power
unit. Loosen belt guide on idler pulley.
7. Remove the belt.
Installation
ADJUSTMENT ROLLER 1/2-LINK
Reverse of removal.
FS7054 SWEEPER
19