Hitachi P55H4011 - Manual (Page 13)

13
test-bleed 3/3/06 10:18 AM
REMOTE CONTROL sensor
Point your remote at this area when selecting
channels, adjusting volume, etc.
ቪ
INPUT- FRONT JACKS
INPUT - FRONT provide composite Video jacks for
connecting equipment with this capability ,
such as a DVD player or Camcorders .
Front Panel Controls
POWER light indicator
To turn the TV ON, press the main power
switch located on the lower right side of the
TV. A red stand-by indicator lamp located on
the lower right corner of the front bezel will
illuminate. The Plasma TV is now ready for
remote ON/OFF operation.
NOTES: 1. Your HITACHI Plasma TV will appear to be turned OFF (lights orange) if there is no video input
when INPUT : 1, 2, 3, Front and HDMI 1, 2 , Front. Check the Power Light to make sure the TV
is turned off or in Stand-by mode (lights red) when not in use.
2. Remote Control can not turn ON/OFF the “MAIN POWER” of the TV.
Indicating Lamp
R/C sensor
ቫ
ቭ
ቪ
ቫ
Indicating Lamp Power Status Operating
OFF. When the main power switch is set to Off.
When the main power switch on the TV is ON.
(Stand-by)
On
TV MAIN POWER is ON with no signal input
(Power Saving) except antenna (no sync. signal).
Off
Lights
Red
OFF.
Lights
Blue TV MAIN POWER is ON ; picture is shown.
Lights
Orange
Off
Blinking
Blue 3 times On When TV receive the IR signal once from R/C.
F
ir
s
t
ti
m
e
u
s
e