Harman-Kardon HA160-0004-A - Manual (Page 22)

Remote Contr
ol Pr
ogramming
18
Signature 2.0
To program the remote, follow these steps. Note that
it is not necessary to program all keys, only those that
are required to operate the subject device. Keys not
programmed will retain the codes preprogrammed at
the factory.
1. Slide the Use/Learn switch e at the top left corner
of the remote to the right so that it is next to Learn .
2. If one of the multifunction buttons is being
programmed press the source button (e.g., CD , Vid 1 )
you wish to have this function associated with. If you
are programming a single function key, proceed to the
next step.
3. Press the button on the remote that is to be
programmed. Note that the Learning LED b
will illuminate.
4. Place the 2.0’s remote head to head with the other
remote control whose function is being learned. The
two remotes should be no more than 8 inches apart.
5. Press and hold the button on the other remote
corresponding to the function to be memorized until
the Learning LED starts to blink. When the LED goes
out, release the button on the transmitting remote. The
function code has been successfully captured by the
2.0’s remote.
NOTE: If both LEDs flash during a programming
operation, it indicates that the remote’s memory is full
or that the remote codes from the transmitting remote
are not compatible with the unit’s signal format.
6. Continue to program any additional remote com-
mands required using steps 2 through 5. When you have
finished programming the remote, slide the Use/Learn
switch e to the left so that it is in the Use position.
Resetting the Remote Memory
In normal operation, codes for a new device may be
programmed “over” the codes that have been previously
programmed into the remote. It is also possible to reset
the memory for individual keys, or for the entire remote.
When a memory position is reset, the remote will return
to the original factory preset command.
To reset the memory for a specific individual key
location, put the Use/Learn switch in the Learn
position. Press the Main Power Off button a and the
button to be reset at the same time. Both the Sending
and Learning indicators will light momentarily. When
the lights go out, the memory has been cleared of the
user programmed code and reset to the factory preset.
Return the Use/Learn switch e to the Use position
when you are finished.
To reset the remote’s entire memory and return all
keys to their factory preset commands first put the
Use/Learn switch e in the Learn position. Then
press the Main Power On button a and confirm
that the Learn LED b has illuminated. While con-
tinuing to press the Main Power On button, press and
hold the Main Power Off button a button until the
Learn LED goes off for about 3 seconds. It will then
blink twice. Then release the two buttons. This
indicates that the memory has been cleared of any
user programmed commands and that the original
commands have been restored. Slide the Use/Learn
switch e back to the Use position to return the
remote to normal operation.