Hitachi C 10FS - Manual (Page 14)

14
English
3. Checking the saw blade lower limit position
Check that the saw blade can be lowered 13/32" to 27/64" (10mm to
11mm) below the table insert.
If necessary, adjust as follows:
(1) Loosen the 8mm wing nut and the two 8mm nuts on the 8mm
depth adjustment bolt.
(2) Turn the 8mm depth adjustment bolt as necessary to set the
lower limit position.
(3) Once the adjustment is complete, fully tighten the two 8mm
nuts and the 8mm wing nut.
NOTE: Before tightening the two 8mm nuts and the 8mm wing
nut, confirm that the saw blade is adjusted so that it will
not cut into the turntable.
Fig. 10
4. Oblique angle
Before the power tool is shipped from the factory, it is adjusted for
0°, right angle, left 45° bevel cutting angle and right 45° bevel cutting
angle with the 6mm bolt (A), 6mm bolt (C) and the 8mm bolt (B).
When changing the adjustment, change the height of the 6mm bolt
(A), 6mm bolt (C) or the 8mm bolt (B) by turning them.
When changing the bevel angle to the right 45°, pull the fixing pin
on the direction shown in Fig. 11 and incline the motor head to the
right.
When adjusting the motor head to 0°, always return the fixing pin
to its initial position.
Fig. 11
5. Securing the workpiece
WARNING: Always clamp or vise to secure the workpiece to the fence; otherwise the workpiece
might be thrust from the table and cause bodily harm.
6. Installing the holders ... (Optional accessory)
The holders help keep longer workpieces stable and in place dur-
ing the cutting operation.
(1) As indicated in Fig. 12, use a steel square for aligning the upper
edge of the holders with the base surface.
(2) After aligning, secure the holders with the 6mm knob bolts (Op-
tional accessory).
Fig. 12
8mm Wing Nut
8mm Depth
Adjustment
Bolt
Turntable
Table Insert
8mm Nut
(2 pieces)
6mm Bolt (C)
(Stopper for right 45°
bevel angle)
Indicator
Fixing Pin
6mm Bolt (A)
(Stopper for 0°)
Base Surface
6mm
Knob Bolt
(Optional
Accessory)
Holder
Steel
Square