FRIGIDAIRE 316488524 - Manual (Page 15)

15 15 15 15 15
Control buttons
Control buttons
button is pressed, the fan will be set to first
speed.
• If the fan is at third speed and the “ ” key is
pressed, the fan will be set to second speed.
• If the fan is at fourth speed and the “ ”
button is pressed, the fan will be set to third
speed.
• If the fan is OFF and the “ ” button is
pressed, the control backlight will light up.
5. “ 5. “ 5. “ 5. “ 5. “ ” Button. Speed Incr ” Button. Speed Incr ” Button. Speed Incr ” Button. Speed Incr ” Button. Speed Increase / ON ease / ON ease / ON ease / ON ease / ON
• This button is used to increase the fan speed,
or turn ON the fan.
• The fan will turn ON if the “ ” button is
pressed and the hood was OFF.
• If the fan is at first speed and the “ ” button
is pressed, the fan will be set to second
speed.
• If the fan is at second speed and the “ ”
button is pressed, the fan will be set to third
speed.
• If the fan is at third speed and the “ ”
button is pressed, the fan will be set to fourth
speed.
• If the fan is at fourth speed and the “ ”
button is pressed, a beep will sound.
IMPORTANT: If the hood doesn’t switch ON, before
calling for service, check if the internal General ON/
OFF Pushb-utton Switch is switched ON.
This hood is equipped with an electronic motor and
lamp control.
The control is able to set 4 different fan speeds, turn
ON/OFF light and has a timer function.
In the following drawing are described the main key
functions.
1 2 3 4 5
1. Light Button 1. Light Button 1. Light Button 1. Light Button 1. Light Button
• Press lamp button to turn ON the light (Lamp
state previously OFF).
• Press lamp button to turn OFF the light (Lamp
state previously ON).
2. Timer Button 2. Timer Button 2. Timer Button 2. Timer Button 2. Timer Button
• The default timer setting is 10 minutes, and it
can be adjusted between 20 minutes and
1minute.
• After pressing the timer button, the control
enters to a timer setup mode, and user can
adjust the timer countdown time with the
“
” and “ ” buttons within 5 seconds.
The timer can be initiated immediately
pressing the timer button, after setting the
timer duration or pressing the timer button
twice (default 10 minutes setting).
• If no action occurs within 5 seconds, the
countdown will start.
• During the timer setup the “ ” and “ ”
buttons are dedicated to the timer and no
motor action will occur.
• Once the timer is initiated, it can be cancelled
by pressing the timer button again.
3. Display 3. Display 3. Display 3. Display 3. Display
• Shows the hood settings.
4. “ 4. “ 4. “ 4. “ 4. “ ” Button. Speed Decr ” Button. Speed Decr ” Button. Speed Decr ” Button. Speed Decr ” Button. Speed Decrease / OFF ease / OFF ease / OFF ease / OFF ease / OFF
• This button is used to decrease the fan speed,
or turn OFF the fan.
• The fan will turn OFF if the “ ” button is
pressed and the hood was in the first speed.
• If the fan is at second speed and the “ ”
General ON/OFF
Push button Switch
Back side of the hood
Frontside of the hood