Fluke Computer Accessories - Manual (Page 49)

User’s Guide – version 3.5 NetFlow Tracker
49
sample – specifies the source long-term data to use
10minute Daily data (ten minute samples) will be used
1hour Weekly data (one hour samples) will be used
6hour Monthly data (six hour samples) will be used
12hour Quarterly data (twelve hour samples) will be used
1day Half-yearly data (one-day samples) will be used
2day Yearly data (two-day samples) will be used
Filter Parameters
Any number of filters can be applied to a report. Each filter is a set of acceptable
values for a certain aspect of the source data. If a filter is not specified then all values
for that aspect are accepted.
To specify multiple acceptable values for a filter, include the parameter name and value
in the URL once for each value.
Note that the filters that can be applied to a long-term report depend upon its type.
sf – specifies a saved filter to apply to the report. The ID for a saved filter is available
in Report Settings .
<id> A saved filter ID
device – specifies the address of an acceptable NetFlow-exporting device.
<addr> The address in dotted-decimal format (a.b.c.d)
inif – specifies an acceptable input interface, thus selecting inbound traffic on the
interface.
<addr>/<id> The interface with addr being the address of the
NetFlow-exporting device in dotted-decimal format and id
being the NetFlow Tracker-specific interface identifier
<addr>/-<ifindex> The interface with addr being the address of the
NetFlow-exporting device in dotted-decimal format and
ifindex being the current SNMP interface index
assigned to the interface
outif – specifies an acceptable output interface, thus selecting outbound traffic on the
interface. Format as for inif above.
if – specifies an acceptable input or output interface of the flow, thus selecting traffic
passed in both directions across the interface. Format as for inif above.