Frymaster GF14 - Manual (Page 12)

1-8
1: Remove these screws
to release guard.
3: Press down on top of thermopile,
forcing it out of the pilot bracket.
2: Bend this clip outward to
release thermopile.
3. To replace the complete pilot assembly:
a. Disconnect the pilot tube from the bottom of the pilot assembly.
b. GF14: Remove the screws from the pilot-mounting bracket to release the pilot assembly.
GF40: Remove the burner manifold assembly in accordance with Steps 1-5 of Section 1.8.3.
c. Disconnect the thermopile lead from the gas valve pilot coil.
d. Reverse steps a through c to install the replacement pilot assembly.
4. Reinstall the burner assembly by reversing steps 1-5 of Section 1.8.3.
5. Verify that the pilot flame is 1 to 1½-inches long. If not, adjust the pilot flame length in
accordance with Section 1.7.
1.7.6 Replacing the Frypot
1. Drain the frypot and disconnect the fryer from the gas supply.
2. Remove all accessories (e.g., frypot covers, drop-in probes, basket hangers, etc.).
3. Remove the screws from the sides and back of the flue cap and lift it off the fryer.
4. Remove the screws from the front cowling (front panel) and pull the bottom edge forward
enough to disengage the upper door hinge pin from the hole in the bottom of the cowling. Catch
the door with one hand to prevent it from falling when the hinge pin disengages.
5. Remove the door by lifting it upward to disengage the lower hinge pin from the hinge bracket,
being careful not to lose the three Teflon spacers located between the lower edge of the door and
the hinge bracket.
6. Remove the cowling by pulling its bottom edge outward slightly and slipping the upper edge
downward from under the front lip of the frypot.