Frymaster GF14 - Manual (Page 9)

1-5
4. Ensure threads inside the fitting are clean and apply a small amount of Loctite™ PST56765
compound or equivalent to the threads of the new high-limit and screw it securely into the fry-
pot.
5. Connect the wires to the gas valve terminals as shown in the illustration below (polarity does not
matter).
Attach hi-limit
wires to these
terminals.
Polarity does
not matter.
1.7.3 Replacing
Deflectors
1. Drain the fryer and disconnect it from the gas supply.
2. Disconnect the wires from the gas valve terminal block, marking each wire to facilitate
reconnection.
3. Disconnect the pipe union collar at the right side of the gas valve.
4. On GF40 fryers, remove the burner heat shield hanger screws at the front of the burner and
remove the heat shield.
5. Remove the burner hanger screws and lower the front of the burner assembly. Pull it forward to
clear the rear burner hanger, then lower the burner to the floor of the cabinet. Carefully pull the
burner assembly from the cabinet.
6. GF14: Use a ½-inch box end wrench to remove the brass orifice that holds the deflector to the
burner manifold. Position the new deflector and reinstall the orifice.
GF40: Use a ½-inch box end wrench to remove the brass orifices that holds the deflector to the
burner manifold. Position the new deflector and reinstall the orifices.
WARNING
Use extreme care to prevent cross-threading and stripping when reinstalling the
brass orifices.
7. Reverse steps 1-5 to reinstall the burner assembly. Check spacing and alignment of targets in
accordance with Section 1.6.