Installation – FMI COMFORT FLAME CDCFPRB User Manual

Page 9

Advertising
background image

www.fmiproducts.com

124979-01C

9

iNsTallaTioN

IMPORTANT: Vent-free fireplaces add mois-
ture to the air. Although this is beneficial,
installing fireplace in rooms without enough
ventilation air may cause mildew to form from
too much moisture. See Air for Combustion
and Ventilation,
page 6.
Note: Your fireplace is designed to be used in
zero clearance installations. Wall or framing ma-
terial can be placed directly against any exterior
surface on the rear, sides or top of your fireplace,
except where standoff spacers are integrally at-
tached. If standoff spacers are attached to your
fireplace, these spacers can be placed directly
against wall or framing materials.
Note: When installing fireplace directly on
carpeting, tile or other combustible material,
other than wood flooring, the fireplace shall be
installed on a metal or wood panel extending
the full width and depth of the fireplace.
Use the dimensions shown for rough openings
to create the easiest installation (see Built-In
Fireplace Installation
, page 10).

CHECK GAS TYPE

Use the correct gas type (natural or propane/LP)
for your unit. If your gas supply is not correct,
do not install fireplace. Call dealer where you
bought fireplace for proper type fireplace.

WARNING: This appliance is

equipped for either natural gas

or propane/LP gas but not both.

Gas type is indicated on the rat-

ing plate. Field conversion is not

permitted.

INSTALLATION ITEMS

Before installing fireplace, make sure you
have the items listed below.
• external regulator (supplied by installer, for

propane/LP units only)

• piping (check local codes)
• sealant (resistant to propane/LP gas)
• equipment shutoff valve *
• test gauge connection*
• ground joint union
• sediment trap
• tee joint
• pipe wrench
* An equipment shutoff valve with 1/8" NPT
tap is an acceptable alternative to test gauge
connection. Purchase the optional equipment
shutoff valve from your dealer. See Accesso-
ries
, page 31.

NOTICE: This heater is intended

for use as supplemental heat. Use

this heater along with your primary

heating system. Do not install this

heater as your primary heat source.

If you have a central heating system,

you may run system’s circulating

blower while using heater. This will

help circulate the heat throughout

the house. In the event of a power

outage, you can use this heater as

your primary heat source.

WARNING: A qualified ser-

vice person must install fire-

place. Follow all local codes.

WARNING: Never install the

fireplace

• in a bedroom or bathroom

• in a recreational vehicle

• where curtains, furniture, cloth-

ing or other flammable objects

are less than 36" from the front,

top or sides of the fireplace

• as a fireplace insert

• in high traffic areas

• in windy or drafty areas

WARNING: Never install in a

bedroom or bathroom. Any heat-

ing product with a btu/Hr rating

over 10,000 cannot be used in a

bedroom.

CAUTION: This fireplace cre-

ates warm air currents. These cur-

rents move heat to wall surfaces

next to fireplace. Installing fireplace

next to vinyl or cloth wall coverings

or operating fireplace where impu-

rities (such as, but not limited to,

tobacco smoke, aromatic candles,

cleaning fluids, oil or kerosene

lamps, etc.) in the air exist, may

discolor walls or cause odors.

Advertising
This manual is related to the following products: