Foster Induction Hobs 7372 241 - Manual (Page 13)

30
Safety functions and error display.
ERROR CODE
ERROR DESCRIPTION INSTRUCTION MANUAL
FA Anomaly of infrared signal, of on/off key -
all cooking zones are deactivated CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FC Receiver infrared anomaly of button
on/off - all cooking zones are deactivated CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FE Touch control ntc sensor: short circuit on
ntc sensor.- all cooking zones are
deactivated CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FT Touch control ntc sensor: ntc sensor
opening - all cooking zones are
deactivated CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
Fc Touch control ntc sensor: ntc sensor
overheating - all cooking zones are
deactivated Switch the hob off and in case also the
underbuilt-in ofen since completely
cooling. Turn on the hob to check all
functions. If the problem remains
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FH Eprom (memory) of Touch control:
anomaly of touch control eprom. - All
cooking zones are deactivated CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FJ Anomaly of adc, of on/off key - all
cooking zones are deactivated CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FO Touch Control Sotware: anomaly on the
touch control software. - All cooking
zones are deactivated CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FL Touch Control luminosity: excessive
external luminosity that hampers t/c
sensors (push buttons) calibration - All
cooking zones are deactivated Remove or replace the external
luminosity source. If the problem remains
despite the calibration conditions have
been respected : CONTACT
AUTHORIZED CENTER FOR
TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FU Touch Control Divider: anomaly on the
t/c Divider. - All cooking zones are
deactivated CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F5 Anomaly in the communication between
touch and power board - - all cooking
zones are deactivated an error is
visualised on all displays CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F1 Short circuit of temperature sensor of
heating elements - the only cooking zone
with the anomaly is deactivated - and
error is visualised on the relating display CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F2 Opening of ntc sensor- the only cooking
zone with the anomaly is deactivated -
and error is visualised on the relating
display CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F8 Anomaly on the NTC sensor - the only
cooking zone with the anomaly is
deactivated - and error is visualised on
the relating display CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F7 Anomaly on the NTC sensor - the only
cooking zone with the anomaly is
deactivated - and error is visualised on
the relating display CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F9 Over-current generator - all cooking
zones are deactivated an error is
visualised on all displays CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
Alternate flashing of cooking
level set by user and of the
letter “C” Over-temperature of generator due to
intensive use or another use different
from domestic use IF HOLD OVER, CONTACT
AUTHORIZED CENTER FOR
TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F3 Short circuit of NTC sensor - all cooking CONTACT AUTHORIZED CENTER