FRIGIDAIRE 297298700 - Manual (Page 8)

8
DOOR REMOVAL / ELECTRONIC CONTROL
DOOR REMOVAL
If door must be removed:
• Unplug the unit or switch the breaker that supplies
power to the unit to the off position.
• Remove the plastic top hinge cover.
• Hold the door in place while removing the top hinge
from the cabinet.
• Remove the two 3/8” hex head bolts from the top
hinge with a 3/8” wrench or socket.
• Lift the door upwards and pull up and away from the
cabinet until free of the bottom hinge pin mounted
on the front of the cabinet.
• To replace the door, reverse the above procedures
and securely tighten all screws to prevent hinge
slippage.
SETTING THE PRO-SELECT™ ELECTRONIC CONTROL
Cool Down Period
For safe food storage, allow four (4) hours for refrigerator to cool down completely. The refrigerator will run
continuously for the fi rst several hours.
Pro-Select™ Electronic Control
The Pro-Select™ Electronic Control is located inside the refrigerator. Temperature is factory preset to provide satisfactory
food storage temperatures. However, the temperature control is adjustable to provide a range of temperatures for your
personal satisfaction.
To adjust the temperature setting, press the UP (▲) key for warmer temperature and DOWN (▼) key for colder
temperature on the control panel. Allow several hours for the temperature to stabilize between adjustments. The
refrigerator can be adjusted between 33°F (1°C) and 46°F (8°C). By pressing the TEMP MODE key, the temperature
display will toggle between °F to °C.
To turn the refrigerator OFF, press the UP (▲) key until the warmest temperature setting of 46F° (8C°) shows in the
display. Then press the UP (▲) key three (3) times within three (3) seconds to turn the refrigerator OFF. The display
will then show “OF”. To turn the unit back ON, press the DOWN (▼) key three (3) times within three (3) seconds.
The control will then display “46F° (8C°)” and may be adjusted to the desired temperature.
Hinge Cover
Hinge Bolts (2)
Hinge Plate
°F
CAUTION
Doors are heavy. It is recommended to have two
people to remove or replace the door assembly from
the cabinet.