FRIGIDAIRE 318203860 - Manual (Page 17)

17
Fig. 1 Fig. 2 Fig. 3
To Set the Warmer Drawer Controls:
The control and indicator lights for the Warmer Drawer features are located on the control panel. The temperatures are
approximate, and are designated by HI (high), MED (medium) and LO (low).
1. Touch the (see Fig. 4) pad at the Warmer Drawer control position. The Warmer Drawer indicator light will flash. Note:
If no further pads are touched within 25 seconds the request to power the Warmer Drawer ON will clear.
2. Set the desired power level. Touch once to turn ON the power level for HI (see Fig. 1) or to turn ON the power
level for LO (see Fig. 3). The Warmer Drawer indicator light located beside the pad will turn ON steady.
3. Each touch of the or pads will decrease or increase through 5 power levels from HI (see Fig. 1) to MED (see Fig.
2) to LO (see Fig. 3). Note: For best results, preheat the Warmer Drawer before adding the food . An empty drawer will preheat
in approximately 15 minutes.
4. When the food is ready for removal, touch the pad once to turn the Warmer Drawer OFF.
The Warmer Drawer indicator light will turn OFF.
Note: The Warmer Drawer is inoperable during the self-clean cycle.
Note: The warmer drawer is equipped with
a latch which may require extra force when
opening and closing the drawer.
Setting Warmer Drawer Control (If Equipped)
Fig. 4