Meridian Audio DVP1500 - Manual (Page 11)

The OSD consists of four menu tabs:
Input – Picture – Display – Patterns
Input Menu
Formats
Input Select: OSD
Video-S-Video- RGB-YCrCb-DVI
Note: Note: The Pass-Thru input cannot be selected
from the OSD since an OSD is not available on that
input. Use the Input button on the remote to select it.
The DVI Input will not display an OSD unless there is
a source connected to it.
Aspect Ratio*
4:3-Letterbox-Anamorphic
Note: This selection should match the aspect ratio of
the source, not the display. The aspect ratio of the
display should be selected in the Setup menu.
Profiles-
Profile: Factory-1-2-3-4-5-6-7-8
Store: 1-2-3-4-5-6-7-8
To store a Profile (in the Input Menu):
• Press Menu button on the remote
• Make all required adjustments.
• Use the Function Up/down keys to
select Profile
• Use the Value Left/Right keys to select Profile
• Press Enter
To recall a Profile (in the Input menu):
• Press Menu button on the remote
• Use the Function Up/Down keys to
select Recall
• Use the Value Left/Right keys to
select profile 1-8
• Press Store
Note: When using a 4:3 source on a Wide Angle
screen there are black bars on the left and right of the
image. The sidebars can be changed to gray using
the Blanking Level control located in the Display
menu. If filling the entire screen is desired, select
Letterbox. The image will fill the screen but the top
and bottom 1/3 of the image will be cut off
(overscanned).
When watching 2:35 aspect ratio movies on a 16:9
(1:77) screen, it is normal to see black bars at the top
and bottom of the image.
Note: The screen shape used in the installation
must be set in the Setup Menu during installation for
proper Aspect Ratio mapping. Anamorphic Aspect
Ratio with 4:3 screens and the Wide-4:3 settings are
not available on units with scan rates 480p, 540p,
600p and Frame Doubling. See Setup section
for details.
Note: Do not leave the 4:3 image with a Wide Angle
screen on for long periods of time on a CRT
projector or plasma display. This can cause
permanent image burn-in. Image burn-in is
not covered by Faroudja’s warranty
Picture Menu
Use these commands to fine-tune the image.
7
OSD / OPERATING INSTRUCTIONS
INPUT PICTURE DISPLAY PATTERNS
FORMATS
INPUTS DVD
ASPECT ANAMORPHIC
PROFILE
RECALL F 1 2 3 4
STORE 1 2 3 4
Press the Function UP/Down
keys until the triangle turns
Yellow. Press the Value Left/Right
keys to cycle to the Menu tabs.
Use the Value left/Right
keys to change selection
or values.
INPUT PICTURE DISPLAY PATTERNS
FORMATS
INPUTS DVD
ASPECT ANAMORPHIC
PROFILE
RECALL F 1 2 3 4
STORE 1 2 3 4
INPUT PICTURE DISPLAY PATTERNS
BRIGHTNESS 50
CONTRAST 50
COLOR 50
TINT 50
DETAIL 4
ADVANCED COLOR SYS NORMAL
Brightness
Factory 50