Meridian Audio DVP1500 - Manual (Page 24)

20
DVD
Press STOP н ( н on the front panel).
Playback stops.
2
1
Press OPEN/CLOSE ( Ȧ
İ
on the front panel).
The disc tray comes out.
3
Remove the disc.
4
The disc tray goes back in.
Press STOP í once.
The display shows “RESUME” and the stop position is
memorized.
• The resume position remains memorized as long as
the disc is in the player — even if you switch the
power off.
• Pressing STOP í twice causes the disc to return to
the beginning when PLAY Ǡ is pressed again. The
display shows the disc type (DVDs or Super VCDs/
Video CDs).
Press PLAY Ǡ .
Playback starts from the resume position.
Notes
• The actual restart position may be slightly before or after
the resume position.
• If you want to remove the disc, but still want to resume
playback from the last stopped position, use the LAST
MEMORY feature instead
(page 48).
Resuming playback from
where you stopped
– DVD/Super VCD/Video CD
Stopping Playback and
Switching Power Off
– DVD/Super VCD/Video CD/CD/MP35
Use the resume feature to restart playback from the
point that the disc was stopped last time.
This features cannot be used with MP3s and CDs.
Using the Setup Screen
Menus
The procedure on this page describes how to operate the
menus on the Setup screen. These menus are used to
set and adjust a number of system settings. The various
functions that can be adjusted are covered throughout
this manual. The procedure on this page provides a basic
outline for using the Setup screen menus.
When setting up for the first time
It is recommended to set up player using the Setup
Navigator (page 17 ). If you selected [Auto Start Off]
when the Setup Navigator appeared, you may still set up
the player using the Setup Navigator in the General menu
screen.
If you choose not to use the Setup Navigator, be sure to
make the necessary settings in the Setup screen
Audio 1, Audio 2, Video 1, Video 2 and Language
menus as described on the following pages.
Some DVDs start playing automatically when loaded in
the player. If a DVD has been loaded, be sure to press
STOP
࡯ before proceeding.
1
NOT ACTIVE
2
Press SETUP.
The Setup screen appears.
Example
Adjusting Audio
and Video
Settings
V2 Video1 General A2 Language
Exit Move
Audio DRC
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out
Audio1
—
—
—
—
— Off
Dolby Digital
Off
96kHz
ᕣ 48kHz
MPEG ᕣ PCM
Setup audio
Digital output format/tone adjust
SETUP
Press the Power button on the small
remote or the front panel