FRIGIDAIRE 950 Series - Manual (Page 6)

6
To select heated dry, press the pad a second
time. The light above the pad will turn off.
Heated dry provides faster drying since the
heating element is on during the drying portion
of the cycle.
You may see water vapor coming from vent
during the rinsing and drying portion of cycle.
The vent is closed during washing to hold
moisture and sound inside. The vent opens
during the last few minutes of the final rinse
and remains open for drying. The drying option
may be changed at any time during the cycle
and affects only the drying period.
Opening the door longer than one minute
during the dry cycle cancels the selected dry
program.
Delay Start
The DELAY START option allows you to delay
starting your dishwasher up to 6 hours. Press
the pad once for a 2-hour delay, twice for 4
hours or three times for 6 hours. A light will
come on indicating the delay start hours and
will remain on until cycle starts.To cancel the
DELAY START option and begin the cycle
before the delay period is over, press the
START/CANCEL pad.
To Cancel a Cycle
You can cancel a cycle anytime during the
cycle. Press START/CANCEL pad and the
dishwasher will start a 90 second drain. At the
end of the drain, select the desired cycle.
Status Indicator Lights
The WASHING light comes on at the
beginning of cycle and remains on until the
end of the main wash.
The RINSING light will come on and remain
on during the last two rinses of all cycles.
The DRYING light indicates the drying portion
of the cycle. The light will come on when either
drying option is selected.
The CLEAN light will come on at end of cycle
and remain on until door is opened.
Child Lock Controls
To prevent children from accidently changing
the dishwasher cycle or starting the
dishwasher, lock the dishwasher controls by
pressing and releasing the HEAT DRY OFF
pad, then pressing and holding the HEAT DRY
OFF pad for 5 seconds. The CONTROLS light
will come on and no new selections can be
made until the lock is released. To unlock the
controls, press the HEAT DRY OFF pad for 5
seconds until the CONTROLS light goes out.
Electrical Power Interruption
When first installed or when power has been
interrupted, HI-TEMP WASH and HEAT DRY
OFF status lights will flash. To clear, press
START/CANCEL pad. If power failure occurs
during a cycle, it will be necessary to restart
the dishwasher by resetting the cycle you
want.
Operating Instructions
(continued)