Foster Induction Hobs 7322 240 - Manual (Page 10)

23
WHAT TO DO IN CASE OF A PROBLEM
The symbol [ E 4 ] displays :
 The hob must be configured according to the following procedure.
I)
Warning : before starting all pots must be removed from the cooktop.
II)
Disconnect the cooktop from the main supply : remove fuse or disconnect circuit
breaker.
III)
Connect the cooktop to the main supply : replace the fuse or connect the circuit
breaker.
IV)
Procedure : You must provide yourself with a ferromagnetic bottom container 16 cm
minimum diametre.
* start within 2 minutes after the connection to the main supply
* do not use the [ O/I ] key.
V)
How to cancel the existing configuration :
1)
Push on the locking key and keep your finger on the key
2)
With a finger from the other hand activate successively and quickly a - b - c
(7322240)
or d - e - f (7321240) keys. Start from left to right. A double "beep"
sound will inform you of a bad manipulation and you will have to restart from
point 1.
3)
The left display shows alternatively a [ C ] and a [ 0 ]
4)
Press the key lock until both displays indicate either [ C ] or [ - ].
5)
Take your fingers away from the keys and press again the [ - ] key during a few
seconds until some [ E ] appear.
6)
You will hear a "beep" sound and the [ E ] will blink.
7)
The [ E ] are automatically transformed into [ C ] → The configuration has been
canceled.
VI)
How to configure the hob ?
1)
Use a suitable induction pot with a minimum diametre size of 16cm.
2)
Select the heating zone by pushing the corresponding [ + ] key.
3)
Put the pot on the corresponding heating zone.
4)
Wait until [ C ] converts to [ - ]. The zone is configured
5)
Use the same procedure for each other heating zone which displays [ C ]
6)
The configuration is made if all zones are detected and if nothing is displayed
Use only 1 pot to configure the hob.
Never put two or more pots on the heating zones during the configuration.
 If [ E 4 ] display persists call the After-sales Service
The hob or the cooking zone doesn’t start-up
 The hob is badly connected on the electrical network.
 The protection fuse cut-off
 The locking function is activated
 The sensitive keys are covered of grease or water.
 An object is put on a key.
a b c d e f