Farallon Communications NetLINE - Manual (Page 16)

16 Chapter 3
N ET LINE C ARD LED S
The NetLINE Card LEDs on the end of the adapter cable
can give you information about link status and network
activity. After the card and driver are properly installed,
the LEDs will become active.
Link: When the LED is lit green, the card has link at
10Mbps.
If the Link LED is not on, and you have a network cable
connected to the card, it may indicate one of the
following:
■ The network cable is not properly connected or is
faulty.
■ No 10Base-T device is connected at the other end of
the cable.
■ The network cable exceeds 100 meters.
■ The card is not connected properly.
■ You are using a straight-through 10Base-T cable to
connect directly to another workstation without a hub.
■ You are using a cross-over cable to connect to a hub.
Power/Activity: A flashing green light indicates that
network data is being transmitted or received by the card.
If the light is off, the adapter cable is not receiving power.
PWR/ACT
LINK