First Virtual Communications Voyager 3000 - Manual (Page 33)

Installation and Setup
2-13
Refer to Figure 2-15 and remove the ACMs by unscrewing the large single screw, swinging
back and unclipping the snap-on wiring connector.
Installation of an ACM is simply a reversal of the above procedure.
Component Insertion and removal
Drive Insertion
Push the device firmly into the device bay slot. Do not attempt to slam it into position. Ensure
that the button at the front of the carrier is fully extended after device insertion. Failure to do
so may result in an incorrectly latched device. In situations where the button is not fully
extended it may be necessary to apply additional pressure.
SCA devices are hot swappable within the system. The only requirement is that there must be
no I/O activity to the device being removed. If the drive has failed and has been dropped by
the controller then no I/O will take place to that unit and swapping is permissible. This
conforms to case 4 of Hot Plugging as defined in the SCSI specification.
9
Drive Removal
Prior to complete removal of the carrier from the VOYAGER 3000 system you must ensure
that the drive has fully spun down as centrifugal forces may damage the device. You must
ensure that adequate shock and anti-static precautions are complied with.
9 SPI Rev 14 Annex A
Figure 2-15 Rear view of ACM assembly