First Virtual Communications Voyager 3000 - Manual (Page 70)

Voyager 3000 User Guide
5-6
SCSI Reset at Power-Up Setting
1 Press ENT for two seconds for the Main Menu.
2 Press t or s to select Edit SCSI Reset at Power-up
and press ENT.
Edit SCSI Reset
at Power-up ..
3 Press ENT for two seconds to change from enable to
disable or vice versa.
Disable SCSI Reset
at Power up?
The controller must be reset (e.g., by powering-off then on again, by executing "Reset This
Controller" via LCD interface, etc.) for this to take effect.
Sequential Drive Spin-Up Setting
To prevent overloading the power supply when several drives turn on at the same time, the
VOYAGER 3000 can sequence the drives to start spinning in succession at five seconds
interval. This is not necessary with the VOYAGER 3000 Power Supply Units
To use this option:
1 Press ENT for two seconds for the Main Menu.
2 Press t or s to select Edit Drive Spin-up and press
ENT.
Edit
Drive Spin-up ..
3 Press ENT for two seconds to change from enable to
disable or vice versa.
Disable Drive
Disk Spin-up ?
The controller must be reset (e.g., by powering-off then on again, by executing "Reset This
Controller" via LCD interface, etc.) for this to take effect.
Data Cache Setting
1 Press ENT for two seconds for the Main Menu.
2 Press t or s to select Edit Data Cache and
press ENT. Edit
Data Cache ..
3 Press ENT for two seconds to change from enable to
disable or vice versa.
Disable
Data Cache ?
The controller must be reset (e.g., by powering-off then on again, by executing Reset This
Controller via LCD interface, etc.) for this to take effect.
Viewing Connected Drives
1 Press ENT for two seconds for the Main Menu.
2 Press t or s to select View SCSI Drives and press
ENT.
View
SCSI Drives ..