FRIGIDAIRE Artic Air Commerical Glass Door Refrigerator - Manual (Page 3)

4
• Refer to the serial plate for correct electrical
rating. The power cord of the appliance is
equipped with a three-prong grounding plug for
protection against shock hazards. It must be plugged
directly into its own properly grounded three-prong
receptacle, protected with a 15 amp time delay fuse
or circuit breaker. The receptacle must be installed in
accordance with the local codes and ordinances.
Consult a qualified electrician. Receptacles with
Ground Fault Circuit Interrupters (GFCI) are NOT
RECOMMENDED. DO NOT use an extension cord
or an adapter plug.
• If voltage varies by 10 percent or more, appliance
performance may be affected. Operating the
appliance with insufficient power can damage the
motor. Such damage is not covered under the
warranty. If you suspect your voltage is high or low,
consult your power company for testing.
• To prevent the appliance from being turned off
accidentally, do not plug the unit into an outlet
controlled by a wall switch or pull cord.
• Do not pinch, knot, or bend the power cord in any
manner.
Other Precautions
• Never unplug the appliance by pulling on the power
cord. Always grip the plug firmly and pull straight
out from the receptacle.
• To avoid electrical shock, unplug the appliance
before cleaning.
Note: Turning the control to OFF turns off the
compressor, but does not disconnect power to other
electrical components.
4. There are four casters in the caster kit. The pair of
casters to be used in the rear, do not have brakes.
Place one of these casters over one of the bolts in
the rear. Place one of the locking nuts on the bolt
to retain the caster. Tighten securely. Repeat to
install the other rear caster.
5. Remove the two 3/8" hex head screws located in
the upper corners of the base panel.Set the base
panel aside.
6. To install the front casters, first put two short bolts
through the rear (non-brake) side of the caster.
Hold the bolts loosely in place by threading several
turns each on the locking nuts. Hold the caster in
position, insert the bolt heads into the base slots,
and slide them back (A). Insert the two front bolts
from the top, and secure with locking nuts (B).
Tighten all locking nuts securely.
7. Reinstall the base panel.
8. Installation is now complete.
9. Tip up the unit with an assistant's help.
Installation and Setup
Inspect for Damage
Inspect the underside of the cabinet and packaging for
damage such as a fork truck can cause, or look for
bent base members from dropping the cabinet. If
hidden damage is found after uncrating, immediately
call the delivery carrier and request an inspection.
Retain all packaging and crating materials until the
inspection is complete.
Uncrate and Set Up
1. Remove carton and all loose parts from inside of
freezer.
2. Tip unit onto its back with the help of an assistant.
3. Remove and discard the two wood skids from
bottom and the four (4) screws. See following
illustration.