Focal DUAL MANAGER - Manual (Page 15)

5.4. Default values
Before Dual Manager has been executed for the first time and Presets have been defined by the user, the
amplifier firmware uses default values for the various parameters, as listed below:
5.5. System and error messages
Hereafter is a list of system and error messages, with their explanations or contexts.
• Loading stages on start-up screen
“Wait hardware.” Wait idle state in hardware.
“Init hardware.” Initialize hardware data.
“Create amplifier screen”, “Init amplifier screen”,
“Read config file”,”First device automatic selection.” Create visual data.
5. Hints and tips
SECTION PARAMETER DEFAULT VALUE
Crossover Slope,dB
Frequency, Hz (High Pass)
Frequency, Hz (Low Pass)
Crossover type
Filter type 12
500
5000
Band-Pass
Linkwitz-Riley
Q-Bass Level, dB
Frequency, Hz
Q 6
80
1.0
Input Section Channel
Input Selector Left/Right
Optical
Output Section Level,dB 0
Equalizer Level,dB
Q
Type 0
2.0
Peak
Time Delay ms 0
Global Headroom (dB)
All On/Off buttons
Inverted button
File name
User mode 6
Off
Off
No Name
Restricted
15