Yamaha BRX-610 User Manual
Page 45
TROUBLESHOOTING
43
En
Eng
lish
ADDITIONAL
INFORMATION
No picture.
Incorrect cable connections.
Make sure that the cables are connected correctly.
Make sure that the connected TV is set to the correct
input.
Connect this unit to the TV with VIDEO jack using
the supplied video pin cable.
– If picture is still not displayed with this unit
connected to the VIDEO jack, press and hold
and
on the front panel simultaneously
for around 5 seconds when no disc is inserted and
playback is stopped to switch NTSC/PAL.
TV system is set incorrectly.
Press and hold
and
on the front panel
simultaneously for around 5 seconds when no disc is
inserted and playback is stopped to switch NTSC/
PAL. Set resolution properly again when connecting
through HDMI (p. 37).
—
The power is
suddenly turned off.
The sleep timer is set.
This is not malfunction. Turn on this unit and play
the source again.
[Auto Power Off] is set to [On].
Set [Auto Power Off] to [Off].
Sound is heard from
the speaker on one
side only.
Incorrect cable connections.
Connect the cables properly. If the problem persists,
the cables may be defective.
There is noise
interference from
digital or radio
frequency
equipment.
This unit is too close to the digital or
high-frequency equipment.
Move this unit farther away from such equipment.
—
This unit makes a
snapping sound
when starting
playback or loading a
disc.
These sounds are not malfunctions of this unit but
are normal operating conditions.
—
No sound from the
subwoofer.
The subwoofer is not connected properly.
Check that the subwoofer is connected properly.
The level of subwoofer is low.
Increase the subwoofer level with the SW
(subwoofer) + button.
Sound from the
subwoofer
connected to the
SUBWOOFER pre-
out jack is distorted.
The subwoofer output level from the unit
is too high.
Decrease the subwoofer output level with the SW
(subwoofer) - button, then increase the subwoofer
level with the control on the subwoofer itself.
The system settings
change
automatically.
When [HDMI Control] is set to [On],
operations of the TV (for example,
changing channels, etc.) changes the
system settings.
Set [HDMI Control] to [Off] or set the system again
by using its remote control.
The HDMI control
function does not
work properly.
[HDMI Control] is set to [Off].
Set [HDMI Control] to [On].
The HDMI control function is disabled
on your TV.
Refer to the manual supplied with your TV and
check the setting.
—
The automatic
lipsync is not
effective even [Lip
Sync] is set to [Auto].
The TV does not support the automatic
lipsync.
Set [Lip Sync] to [Manual] and then manually adjust
the audio output delay.
Problem
Cause
Remedy
Page