Furuno GR-80 - Manual (Page 14)

10
Menu Operation
Most functions are carried out through
menus and there are two sets of menus, nor-
mal operation menu and option mode menu.
Normal operation menu
The normal operation menu mostly contains
items used in everyday operations such as
dimmer and contrast level adjustment. The
[MENU] key opens/closes the menu and
goes to preceding menu item when pressed
with a menu option displayed. The arrow
keys scroll the display. Use the [ENT] key
to register option.
Option mode menu
The option mode menu contains the diag-
nostic test and items for setting up the equip-
ment. Press [RESET] while pressing and
holding down [MENU]. Release [MENU]
when the display shows "SELF TEST?" Se-
lection of menu item and option and regis-
tration are the same as in the normal
operation menu. To escape from the option
mode menu, press the [RESET] key.
Menu tree
Figure 9 shows the menu tree.
Figure 9 Menu tree
SET RCV MODE? (AUTO L/L MODE, MANUAL MODE. Default: MANUAL)
[
▼ ]
SET MSK RATE? (AUTO, 25, 50, 100, 200 bps. Default: AUTO)
[
▼ ]
SET STN AREA? (AREA 1, AREA 2, AREA 3. Default: AREA 1)
[
▼ ]
SET DIMMER? (DIMMER 1 – DIMMER 4)
[
▼ ]
SET CONTRAST? (CONTRAST 1 – CONTRAST 8)
[
▼ ]
SET REMOTE? (REMOTE ON, REMOTE OFF)
[
▼ ]
MONITOR SS/SN? (Displays signal strength and signal-to-noise ratio.)
[
▼ ]
MONITOR L/L? (Displays position in latitude and longitude.)
[MENU] key
Option mode menu
SELF TEST? (Diagnostic test)
[
▼ ]
SET BAUD RATES? (300, 600, 1200, 2400, 4800, 9600, 14440, 19200 bps. Default: 4800 bps)
[
▼ ]
SET DATA FORMAT? (6-8, 8-8. Default: 8-8)
[
▼ ]
SET L SCAN TIME? (0 – 99 min. Default: 60 min)
[MENU] + [RESET]
[ ▼ ]
[ ▼ ]