Furuno DUAL GPS GP-150-DUAL - Manual (Page 60)

8. MENU SETTINGS
8-8
To Previous Page
Talker ID GP LC DE
Output Data (00-90 sec) 100%
DATA 4 I/O SETUP <Out> 2/2
MENU : Escape ENT : Enter
Data FMT V1.5 V2.0 IEC
1. AAM:00 APA:00 APB:04 BOD:00
2. BWR:00 BWW:00 GGA:00 GLL:01
3. RMB:01 RMC:00 VTG:01 WCV:00
4. WNR:00 WPL:00 XTE:00 ZDA:01
5. GNS:00 GBS:01 Rnn:00 RTE:00
Figure 8-10 DATA 4 I/O SETUP menu (2/2)
7) Follow "DATA 1 output setting" from step
2.
8.5 Receiving Data from
Personal Computer
Loading waypoint/route data
Waypoints and routes data can be
downloaded from a personal computer,
through the DATA 4 connector.
1) Press MENU ESC, 9 and 5.
2) Press to select DATA 4 Level.
3) Press or to select level of personal
computer; RS232C or RS422.
4) Press the NU/CU ENT key.
5) Press or to select COM.
6) Press to select To Next Page. The
DATA 4 I/O SETUP menu appears.
To Previous Page
Baud Rate 9600 bps
Command Stop Start
Save Data WPT/ROUTE
Command Stop Start
DATA 4 I/O SETUP <COM> 2/2
MENU : Escape ENT : Enter
: Select
Load Data WPT/ROUTE WPT
Figure 8-11 DATA 4 I/O SETUP menu (2/2)
7) Press to select Baud Rate.
8) Press or to select baud rate; 4800
bps, 9600 bps, or 19200 bps.
9) Press the NU/CU ENT key.
10) Press
or to select WPT/RTE.
11) Press to select Command. Stop, on
the same line as Command, appears in
reverse video.
12) Press to select Start. The message
shown in Figure 8-12 appears.
Loading erases current data
and stops Route navigation
Are you sure to load ?
ENT: Yes MENU:No
Figure 8-12
13) Press the NU/CU ENT key. The message
shown in Figure 8-13 appears.
Now loading
Waypoint/Route data !
MENU:Stop
Figure 8-13
14) Operate the computer to output data.
When data is loaded, the cursor shifts to
Stop.
15) Press the MENU ESC key. When data is
loaded successfully, The message shown
in Figure 8-14 appears.
Loading ended successfully
Press any key
Figure 8-14
If data could not be loaded, the message
shown in Figure 8-15 appears.
Failed in loading
Invalid data
Press any key
Figure 8-15