Furuno DUAL GPS GP-150-DUAL - Manual (Page 62)

8. MENU SETTINGS
8-10
11) Press the NU/CU ENT key. The message
shown in Figure 8-22 appears while data
is being saved.
Now saving
Waypoint/Route data !
MENU:Stop
Figure 8-22
12) Save data at the computer.
13) Press the MENU ESC key. When data is
saved, the cursor shifts to Stop.
14) Press the MENU ESC key.
8.6 WAAS/DGPS Setting
This menu sets the using WAAS or when the
DGPS beacon receiver GR-80 is connected.
The default setting is “GPS”.
WAAS
1) Press MENU ESC, 9 and 7 to display the
WAAS/DGPS SETUP menu.
WAAS Search AUTO MAN (GEO=134)
FREQ 323.0kHz
Baud Rate 200 bps
WAAS/DGPS SETUP
MENU : Escape ENT : Enter
: Select
Mode Of GPS
Corrections Data Set
*
: 00
DGPS Station AUTO MAN List
*: Determines how to use the WAAS signal.
Use the default setting "00".
Figure 8-23 WAAS/DGPS SETUP menu
2) Press or to select WAAS or AUTO.
3) Press to select WAAS SEARCH.
4) Press or to select AUTO or MAN.
DGPS
1) Press MENU ESC, 9 and 7 to display the
WAAS/DGPS SETUP menu.
WAAS Search AUTO MAN (GEO=134)
FREQ 323.0kHz
Baud Rate 200 bps
WAAS/DGPS SETUP
MENU : Escape ENT : Enter
: Select
Mode Of GPS
Corrections Data Set : 00
DGPS Station AUTO MAN List*
: These items appear when "Man" is selected.
*: Only when the internal beacon receiver is equipped.
Figure 8-24
2) Press or to select Mode, and then
press or to choose INT BEACON.
3) Press to select DGPS Station.
4) Press or to select AUTO or MAN
or List.
For automatic search, the GP-150
automatically search DGPS reference
station.
For manual search, enter frequency of
DGPS reference station and select the
transmission rate of that. The List shows
five closest DGPS beacon stations,
including user-programmed stations.
Manual
1) Press or to select MAN.
2) Enter frequency in four digits (283.5kHz
to 325.0kHz, in 0.5 kHz step).
3) Press the NU/CU ENT key. "Baud Rate"
appears in reverse video.
4) Press or to select baud rate; 25,
50, 100 or 200bps.
5) Press the MENU ESC key.