FOCUS Enhancements FS-2 User Manual
Page 31
FS-2/2E Studio DTE Disk Recorder User Guide
11
8. Pr Input
- For connecting the Pr signal from component input sources.
Pr Output
- For output of the Pr signal to component devices
9. Sync Input
- For connecting the Sync signal on non sync on green
component sources.
Sync Output
- For connecting the Sync signal to non sync on green
component devices.
10. Timecode Input
- For connecting external analog VITC timecode
sources.
Timecode Output
- For connection to external analog VITC timecode
devices.
11. Reference Video
- For reference video loop through.
To use this Reference Video input, select
REF VIDEO
from
GENLOCK
in
the
SETUP
menu. If the loop-through jack is not connected, make sure
the output is terminated using an external 75 ohm terminator.
12. AES/EBU Digital Audio Input and Output
- For connecting AES/EBU
input sources or output to AES/EBU devices.
13. Stereo Audio Monitor Output
- For connection of audio monitors.
14. Balanced Analog Audio Input Channels 1 and 2
- For connecting
balanced analog audio input sources.
Balanced Analog Audio Output Channels 1 and 2
- For output to
balanced analog audio devices.
15. AC In
- Use the power cord supplied to connect to the power outlet.
The power module contains a protective fuse. Refer to
on page 15 for more information.
16. Video Monitor Output
- For connection to a video monitor (composite).
Use this connection to view the
On Screen Display
.
17. DV I/O 1
and
DV I/O 2
- For connection of DV video devices. These two
ports are used to pass through the DV signal. The FS-2/2E does not
support multiple DV inputs.
18. To HDD
- For connecting external FireWire 400 disk drives to the FS-2/
2E. Use the FS-2/2E's HDD Bypass function with this port. When a
connection is made with
Front Panel HDD Port Loop Through
, it allows
the front panel FireWire connector to be used for connection of
external FireWire HDDs.
19. To Computer
- For connecting the FS-2/2E to a computer's FireWire
400 port. It allows any disk drives connected to the FS-2/2E to mount
to the computer.
20. Ethernet 10/100 BaseT
- For connecting FS-2/2E to a network or
computers for small file exchange, telnet, or web control. (The web
control functionality is only available for the FS-2E or the FS-2 with the
2.0 upgrade.)