Furuno GP-1650W - Manual (Page 27)

4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1650W)
19
12. Connect the cable assy. S.FL2-2LP0.7-D-WHT (121) of J3 to J2 of the GN-8091.
13. Pass the mini pin coaxial cable of J1 on the GR-7000A through the mini plug on the
ANLG Board and connect it to J8 on the ANLG Board.
14. Mount the ANLG board on the heat sink.
GN-8091
GR-7000A
to J8 of
ANLG board
to J107 of
MAIN board
to J106 of
MAIN board
Connect PH6P-W-L240 between J2 of
GR-7000A and J107 of MAIN board.
Connect mini pin coaxial cable
between J1 of GR-7000A and J8 of
ANLG board.
Connect cable assy.
J3 of GR-7000A to
J2 of GN-8091.
J3
J1
J1
J2
J2
Connect cable assy.
J1 of GN-8091 to J106
of MAIN board.
Heat sink
Clamp
GR-7000A
GN-8091
Mini pin coxial cable
Cable tie
Wiring the Cable assembly
15. Mount chassis assembly on the panel assembly. Connect 8P connector and 6P
connector to Main board as shown in the figure below.
View
Panel assembly
Chassis assembly
Connector
A
A PH8P
J106
PH6P
J107
(P) M
AIN
Attaching chassis assembly