Fuji Bikes Carbon Team Pro (US) - Manual (Page 3)

CARBON SEAT POST INSTALLATION GUIDE
Please read the following instructions. If you have any doubt regarding your mechanical
ability, visit your local authorized Fuji dealer. Fuji recommends that the seat post be installed
according to recommended torque specification.
Please read the following warnings. Failure to follow any warning may result in a catastrophic
failure of the seat post, resulting in serious injury or death. This phrase may not be repeated
in connection with each warning.
Warning: This product is designed for road use only. This seat post is NOT intended
for off-road use.
Warning: Recommended torques in this guide are specific for Fuji seat posts. Refer to
the owners manual for the mating component’s recommended torque. Use the lowers
torque recommendation.
1. SURFACE PREPARATION
Before installing the seat post, follow the steps below:
a. Remove all burrs and square edges from seat tube surfaces in contact with the seat post.
These edges and burrs can dig into the material, compromising the strength of the carbon.
Warning: Any deep scratch or gouge in the seat post can weaken the seat post
resulting in failure, causing serious personal injury or death.
b. Round posts: when using a standard seat clamp mechanism, the seat post collar should be
positioned 180 degrees opposite the seat tube slot. This reduces the possibility of the
edges of the seat tube digging into the seat post, which can compromise the integrity of
the seat post.
c. Remove any grease from internal surface of seat tube. Since composite seat posts are
noNmetallic, they will not seize in the seat tube. Grease reduces the friction that is critical
to proper seat post grip.
Note: DO NOT cut Fuji carbon seat posts!
For additional information, please visit the tech section at www.fujibikes.com
2. SEAT POST SIZING
All posts: To ensure that the diameter of the seat post conforms to the diameter of the seat
tube, check to make sure that there is no play while the seat post is inside the frame. If there
is play or the seat post lowers into the frame with no resistance, have an authorized Fuji
dealer verify the fit tolerance.
Round posts: If the seat post does not install in a straight, smooth fashion, DO NOT TWIST! If
the seat post does not install properly, it is recommended that the fit be verified by an
authorized Fuji dealer. It may be necessary to have the seat tube reamed to fit properly.
Warning: Incorrect sizing of a seat post can result in slippage or failure, causing
serious injury or death.
3. SEAT POST / SADDLE INSTALLATION
Note: Lightly grease saddle clamp bolt threads.