Fluke VICTOREEN 05-437 - Manual (Page 9)

Getting Started
Receiving Inspection
2
2-1
Section 2
Getting Started
2.1 Receiving Inspection
Upon receipt of the unit:
1. Inspect the carton(s) and contents for damage. If damage is evident, file a claim with the
carrier and notify Fluke Biomedical, Radiation Management Services at 440.248.9300.
2. Remove the contents from the packing material.
3. Verify that all items listed on the packing list have been received and are in good condition.
If any of the listed items are missing or damaged, notify
Fluke Biomedical.
2.2 Mounting
The mounting bracket supplied (P/N 102007) may be attached to any convenient vertical mounting
surface. Before mounting the bracket to the wall, however, make sure that the 6 ft. converter power cord
will reach the nearest power outlet.
The wall-mounting bracket comes supplied with double-sided foam tape already attached. Just peel off
the protective paper covering and firmly apply to the mounting surface.
Once in place the bracket cannot be moved or
removed without destroying the tape. Make sure of
your installation site before applying.
2.3 Power
The plug on the end of the converter power cord should first be inserted into the larger jack on the bottom
of the Primalert. The converter should then be plugged into the wall outlet.
Note that when first connected to power, the Primalert may alarm for as long as three seconds before the
automatic reset is actuated.
NOTE
CAUTION