Grizzly G1067Z - Manual (Page 15)

G1067Z Wood Lathe -13-
Figure 10.
Figure 11.
The G1067Z is supplied with a #2 Morse taper
spur center for use when spindle turning. The
spur center is used in conjunction with the tail-
stock live center. Install the spur center by insert-
ing into the hole in the inboard spindle (
Figure
10).
Figure 12.
The G1067Z is supplied with a 6'' face plate.The
faceplate is used for bowl and plate turning.
Install the face plate by threading the face plate
onto the inboard spindle. Use the indexing pin to
hold the spindle from rotating while tightening
down or removing the face plate (
Figure 12). DO
NOT use the face plate in conjunction with the
spur center. Mount your workpiece to the face
plate using the mounting holes bored into the
face plate.
To remove: insert the knockout bar provided into
the outboard spindle and tap with the palm of
your hand while carefully holding onto the spur
center with your other hand (
Figure 11).
Knockout bar
Face Plate Spur Center
The joints of glued-up workpieces should
be high quality to prevent them from break-
ing under the extreme forces of lathe turn-
ing. Consult in-depth trade manuals and
instructional books for correct techniques
when gluing up a workpiece from multiple
pieces. If a joint fails during a lathe turning
operation, serious injury or death could
occur.
The contact area between the workpiece
and the face plate must be flush with one
another. Failure to do this could result in
the face plate distorting or breaking when it
is screwed to the workpiece, or during use,
causing injury or death.