Grizzly H7948 - Manual (Page 10)

H7947/H7948 16 Gauge Stapler -8 -
OPERATIONS
Loading Staples
Use staples meeting the specifications
listed for your stapler on
Page 4 of this
manual.
To load staples in your stapler:
1. DISCONNECT STAPLER FROM THE
AIR SUPPLY!
Point the stapler away from you and
others when connecting the air supply.
The stapler can cycle and discharge a
staple when the air supply is connect-
ed. Ignoring this warning may result in
serious personal injury.
2. Slide the magazine pusher to the rear
of the magazine and pivot the pusher
down until it catches in the lock notch
on the magazine as shown in
Figure
3.
3. With the pusher locked at the rear of
the magazine, insert a strip of staples
into the magazine as shown in
Figure
4.
Figure 4. Loading a staple strip into the
magazine.
4. Lift the pusher out of the lock notch and
guide it forward to push the staple strip
to the nose of the stapler.
Figure 3. Locking the pusher.
To remove unused staples:
1. DISCONNECT STAPLER FROM THE
AIR SUPPLY!
2. Point the stapler away from you and all
bystanders.
3. Slide the pusher to the rear of the mag-
azine and latch it into the lock notch.
4. Move the staples back from the nose
and lift them up and out of the maga-
zine.
Unloading Staples