Grizzly H7948 - Manual (Page 11)

H7947/H7948 16 Gauge Stapler -9 -
Rotating Exhaust
Cover
The exhaust cover rotates as needed to
direct the exhaust away from you.
To rotate the exhaust cover:
1. Use the 4mm hex wrench to loosen the
exhaust cover cap screw as shown in
Figure 5.
Figure 5. Loosening the exhaust cap
screw.
2. Rotate the exhaust cover by hand to
aim the exhaust port in the desired
direction.
3. Tighten the exhaust cover cap screw.
Using the Stapler
Before you operate your stapler, place five
to six drops of air tool oil into the quick
connect fitting where the stapler connects
to the air supply.
To operate your stapler:
1. Connect the air supply to the quick
connect fitting on your stapler.
2. To test for proper staple penetration,
hold the stapler perpendicular to the
surface of a piece of clean scrap wood
that is thick enough for the length of
staples you have loaded.
3. Depress the safety nose mechanism
against your workpiece.
Read the manual before operation.
Become familiar with these staplers,
their safety instructions, and opera-
tion before beginning any work.
Serious personal injury may result if
safety or operational information is
not understood or followed.