Genie Model 2022 - Manual (Page 16)

PN# 37026500123 02/26/2010 REV. 1
16
3. Securely fasten wires.
‡ Securely fasten wires to ceiling and
wall using insulated staples provided.
– Use insulated staples.
– Staples should be snug only.
‡ If rear cover is attached to power head,
remove it.
‡ On power head:
– Route Wall Console wires through wire guide
on power head.
– Split and strip ends of wire (Fig. 3-2 on
previous page) .
– Insert wire into terminal holes and lightly press in
the orange locking clips above each terminal
hole. (You can use a pencil or small screwdriver
to comfortably press in locking clips.) The white
wire into #1 terminal hole and striped wire into
the #2 terminal hole.
– Confirm wire lock by lightly tugging on the wire.
The wire should remain in the terminal hole.
‡ Do NOT install rear cover yet.
4. Mounting .
‡ Fasten Wall Console to wall with 2 screws
(provided) (Fig. 3-4).
‡ Remove protective backing from "Entrapment"
warning label (Fig. 3-5). The "Entrapment" label
is located in the center of this manual.
– Stick label on wall near Wall Console.
FIG. 3-4 Mounting Wall Console.
Child
can
be p
inned
under
automatic
garage
door.
Death or serious injury can result.
‡ Never let child walk or run under moving door.
.
‡ Neve
r let child use door opener controls.
‡ Always
keep moving
door in sight.
‡ If person is pinned, push control
button or use
emergency release.
‡ Test door ope
ner monthly:
Refer to your
owner
'
’
s m anual.
Place 1
1 / 2 -inch object (or 2x4
laid flat) on floor.
If door fails to reverse on contact,
ad just opener.
If opener still fails to reverse door
, repair or replace opener
.
Do not remove or paint over this labe
l.
Mount wall control out of child's reach
(at least 5 f
ee t above floor).
Place next to wall control.
©1999
Insulated
Staple
+ –
P B
Infared Sensor
1 2 3 4 5 6
FIG. 3-3 Insert wires
.
(Power Head With Rear Cover Removed)
1 2 3 4
Terminal
Holes
Locking
Clips
5 6
FIG. 3-5 Mounting Entrapment warning label .
3
2
1
Independent Light Control
– Controls door opener lights from inside garage
– Energy-Saver shut-off turns OFF lights 3 minutes after
door activation
Vacation Locking Switch
– LOCK disables controls after
door is completely closed
– UNLOCK allows controls to
work normally
Door Control "Open/Close" Button
– Open and closes door from
inside garage
wire guide