Goldstar DH50EL DH65E - Manual (Page 6)

6
HUMIDITY
CONTROL
FAN
SPEED
TIMER
BUCKET
FULL High
Low
Continuous On.
4Hr. On/Off
2Hr. On/Off
POWER
Operating your dehumidifier
CONTROL PANEL
The dehumidifier control panel contains: Bucket Full Indicator, Humidity Indicator, Power Control, Humidity Control, Fan
Speed and Timer Control.
Bucket Full indicator ---This light glows when the water bucket is full and needs to be emptied.
Power --- Operation starts when this button is pressed and stops when the button is pressed again.
Humidity Control --- This button controls the humidity in the room.
• : To raise the humidity setting
• : To lower the humidity setting
• The humidity setting can be set to a permanent "On" setting or to a specific humidity setting between 35% and 70%
in 5% increments.
"On" setting - dehumidifier runs continuously regardless of humidity condition.
35% - 70% setting - dehumidifier shuts on and off according to surrounding humidity conditions.
Fan Speed --- This controls the speed of the airflow.
• High: Fan speed is set to high.
• Low: Fan speed is set to low.
• When Fan Speed button is pressed, the fan speed mode is changed.
Energy Timer --- Press this button to select type of operation.
• Select Constantly On for uninterrupted operation.
• Select either 2 or 4 Hr. On/Off for cycled operation:
The unit will operate for 2 or 4 hours, and then shut off completely for 2 or 4 hours.
The cycle repeats until you change the setting.
• When Energy Timer button is pressed, the Timer indicator lights shift as follows:
Continuous On ➔ 2 Hr. On/Off ➔ 4 Hr. On/Off ➔ Continuous On.
Auto Restart --- Once power is restored after a power failure, the unit returns to its previous operation setting. The fan
turns on immediately but, humidity control starts after a 2 minute delay.
TO OPERATE THE DEHUMIDIFIER:
1. Plug the power cord into an electrical outlet. Press the power button.
2. Set the humidity Control to "On" or to a specific humidity level between "35% RH(Relative Humidity) and
70%RH(Relative Humidity)" for normal operation.
If you need drier air, press the
Humidity Control button.
If you need less moister air, press the Humidity Control button.
3. Press the Power button to stop the unit manually.
4. Press the Timer button to set the amount of time you want the unit to run.
At the end of that time, the unit will shut off.
The Timer can be set for : Continuous On, 4 hours or 2 hours.
5. If you want to control the speed of airflow, press Fan Speed button. Each time that the Fan Speed button is pressed,
the fan speed mode is shifted: High ➔ Low ➔ High
Note: Be careful not to lose the water bucket.
This dehumidifier doesn't run if the water bucket is not installed properly.