Garmin 90/140 - Manual (Page 11)

Fishfinder 90/140 Owner’s Manual 5
I
NSTALLING
Y
OUR
F
ISHFINDER
> P
ACKING
L
IST
I
NSTALLING
Y
OUR
F
ISHFINDER
Make sure you completely read and understand all
instructions before you install and use your Fishfinder. If
you have problems, contact Garmin Product Support, or
seek other professional assistance.
You can install the Fishfinder hardware on a transom or on
a trolling motor. Before installation, make sure the wiring
harness can reach the Fishfinder and transducer locations.
Check the packing list below. If you are missing any items,
contact your Garmin dealer.
Packing List (one of each, unless otherwise noted):
A—Fishfinder sonar unit
B1—Swivel mount bracket (Fishfinder
140; optional for Fishfinder 90); or
B2—Tilt mount bracket (Fishfinder 90)
C—Swivel base (Fishfinder 140)
D—Mounting knobs
E—Mounting knob spacer
F—Snap ring
G—Transducer with power cable
H—Transducer mount
I—Trolling motor mount gasket
J—5 mm Flat washers (2)
K—5 x 30 mm Screws (2)
L—10-32 Lock nut
M—4 x 12 mm Screws (4)
N—10-32 x 1.75 Screw
O—1/4" Cable clamps (2)
P—Plastic spacer
Q—1/4" Rubber washer
R—Cable tie, 5.6" (4)
S—Cable tie, 20”
J
K
L
M
N
O
P
Q
R
I
S
G
(Cable not shown)
C
D
E
B1
F
(Fishfinder 90)
B2
(Fishfinder 90)
(Fishfinder 140)
A
H