Grizzly 12" Drum Sander G0459 User Manual

Page 42

Advertising
background image

-40-

Model G0459/G0459P (Mfg. 7/11+)

11. Mark the top of the table lift screws with

arrows (all pointing in same direction) and
mark the screws with liquid correction fluid
above the mounting bracket (

figure 46).

later, when you reassemble the conveyor
table, you can use these marks to reset the
table height close to the current position.

figure 47. Conveyor belt loosened at the front

adjustments (only one shown).

12. Mark the chain and sprockets with correction

fluid.

13. loosen the idler roller sprocket (figure 39),

carefully pull the chain off of all the sprockets,
and remove it from the cabinet.

14. loosen the conveyor belt at the front adjust-

ments, as shown in

figure 47.

neW

photo

figure 46. locations to mark table lift screws.

figure 48. brass shims.

15. disconnect the conveyor feed motor wires

from the circuit board.

16. remove the scale pointer.

Before removing the table, note the number and
location of brass shims (

figure 48) under the

table lift screws. Knowing their correct position
will help you align the conveyor table during reas-
sembly.

brass

shims

figure 49. example of lifting the table off of the

drum sander cabinet with two people.

17. With the help of an assistant, carefully lift

the table off of the drum sander cabinet, as
shown in

figure 49.

Advertising