Grizzly G0561 - Manual (Page 16)

-14-
g0561 7" x 12" Metal-Cutting Bandsaw
A shipping bracket has been installed on the
bandsaw to protect the alignment of the bow dur-
ing shipment. After removal, store the bracket in
a safe place until you need to move or ship the
bandsaw in the future.
To remove the shipping bracket:
1. use a #2 phillips head screwdriver to remove
the top screw and flat washer, use a 14mm
wrench to loosen the bottom hex nut and
remove the shipping bracket shown in
figure
6.
Shipping Bracket
figure 6. removing shipping bracket.
shipping Bracket
Work Stop
Components and hardware Needed: Qty
Work stop ...........................................................1
Work stop rod ...................................................1
To install the work stop:
1. insert the work stop rod through the hole in
the base shown in figure 7 and lock in place
with the hex bolt.
2. slide the work stop over the rod.
3. Measuring from the outside of the blade,
tighten the thumbscrew to set the work stop
at your desired length.
figure 7. installed work stop.
stop rod
hex Bolt