Receiver panel descriptions – Gefen GTV-ETH-2COAX User Manual
Page 10
7
RECEIVER PANEL DESCRIPTIONS
1. Standby Button
Pressing this will put the receiving unit in standby mode. The unit will not
transfer any information to the sending unit in this mode. To release standby
mode, simply press the button again.
2. Ethernet Input Port ( 1 through 4)
Connects to an Ethernet device (i.e a computer or gaming system) via a
standard network cable. 4 ports are available for 4 separate devices.
3. Security/Reset Button
Pressing this button for 2 seconds will activate the Automatic Security
Confi guration (please see page 17). Pressing this button for more than 10
seconds will perform a factory reset.
4. AC Power Cable Input
Input for the supplied AC power cable.
5. Coaxial
Output
Coaxial output to link the sending and receiving units together. This
connector will support RG-6 and RG-59 cables.
6. LAN 1 LED
This LED will activate when a connection from a valid Ethernet device to
Ethernet port 1 is established. It will blink when activity is detected to signify
that data is actively being traffi cked to and from this port.
7. LAN 2 LED
This LED will activate when a connection from a valid Ethernet device to
Ethernet port 2 is established. It will blink when activity is detected to signify
that data is actively being traffi cked to and from this port.
8. LAN 3 LED
This LED will activate when a connection from a valid Ethernet device to
Ethernet port 3 is established. It will blink when activity is detected to signify
that data is actively being traffi cked to and from this port.
9. LAN 4 LED
This LED will activate when a connection from a valid Ethernet device to
Ethernet port 4 is established. It will blink when activity is detected to signify
that data is actively being traffi cked to and from this port.
10. Link LED
This LED will activate once a link has been established between the sending
and receiving units. It will blink when activity is detected to signify that data is
actively being traffi cked to and from the sender.
11. Power LED
This LED will activate once the included power supply is properly connected.