GE Monogram Gas Grill - Manual (Page 16)

The Rotisserie System
Stainless Steel Outdoor Cooking Center
16
Assembly On 24 ″ models the motor is mounted by sliding
it down into place in the metal channel attached
to the right side of the grill. The skewer is
connected to the motor assembly by placing
the pointed end through the motor access hole
in the grill and into the motor. The left side of
the skewer rests in the grill groove.
On 27 ″ models the motor is mounted to a metal
channel which attaches to the left side of the
grill and is tightened into place with a thumb
screw. Ensure that the motor is straight prior to
tightening the thumb screw.
The rotisserie motor on 36 ″ and 48 ″ models is
secured down to a cast rotisserie block with the
black screw-down knob. The rotisserie block is
in turn bolted to the right side panel.
On 36 ″ and 48 ″ models, the skewer or the
rotisserie is attached to the motor assembly by
placing the pointed end into the motor and
resting the threaded end on the support at the
left side (right side on 24
″ and 27 ″ models) of
the grill.
With the skewer pushed as far as possible into
the motor, the grooved skewer bushing should
rest on the left side bracket.
The removable black handle should only be in
place when handling the skewer. Remove the
handle when cooking to allow the lid to close
and avoid melting the handle with heat from
the range-top burners (on some models).
24
″
model rotisserie assembly
36 ″ and 48 ″ model rotisserie assembly
27
″
model rotisserie assembly