Grizzly G4179 - Manual (Page 23)

Model g4179 1 ⁄
2
hp power Feeder
-21-
Wheel Replacement
Figure 15. Wheel replacement.
Cap
screw
2. Using a 5mm hex wrench, remove the two
wheel retaining cap screws ( Figure 15).
3. swap the old wheel with the new.
4. reinstall the two cap screws, and tighten in
an alternating pattern until the wheel is sec-
cure
.
if you damage one or more wheels or they are
worn out, you can easily replace the wheels.
tools Needed Qty
hex Wrench 5mm .............................................. 1
to replace a wheel:
1. disCoNNECt thE poWEr FEEdEr
FroM poWEr!
always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.