GE Built-In Dishwasher - Manual (Page 7)

7
Installation Instructions
STEP 6 POSITION WATER LINE AND
HOUSE WIRING
• Position water supply line and house wiring on the fl oor of
the opening to avoid interference with base of dishwasher
and components under dishwasher.
Figure M
Figure N
Figure O
STEP 7 INSTALL DRAIN HOSE THROUGH
CABINET
• Stand the dishwasher upright and position in front of the
opening. Insert drain hose into cabinet wall hole. If a power
cord is used, guide the end through a separate hole.
TIP: Position water line and house wiring on the floor
to avoid interference with base of dishwasher.
STEP 8 SLIDE DISHWASHER PARTIALLY
INTO CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches at a time.
• As you proceed, pull the drain hose through the opening
under the sink. Stop pushing when the dishwasher is a few
inches forward of adjacent cabinetry.
• Make sure drain hose is not kinked under the dishwasher and
there is no interference with the water line and wiring or any
other component.
Water
Line
House
Wiring
4"
6"
Power Cord
(If Used)
Water
Line
House
Wiring
Drain
Hose
Insulation
Blanket
Maximum
Drain Hose
Length 10”
Do Not Push Against
Front Door Panel With
Knee. Damage to The
Door Panel Will Occur.