Grizzly G1073/G1073Z - Manual (Page 14)

-12- G1073/G1073Z 16" Bandsaw
Figure 8. Pulley speed chart diagram.
V-Belt
To ensure optimum power transmission from the
motor to the band wheels, align the pulleys, and
tighten the V-belt.
To install the V-belt:
Slip the V-belt over the motor pulley and step pul-
ley. Position the V-belt on the pulleys according
to the speed you want (see
Figure 8 for speed
chart). For general woodworking, we recommend
the fastest blade speed.
Figure 7. Plugging cords together.
Wiring The Motor
1. The Model G1073/G1073Z motor and
ON/OFF switch each have a special connec-
tor for ease of wiring. Plug the connectors
into each other as illustrated in
Figure 7.
2. The motor is prewired for 220 volt operation.
Install the appropriate 220V plug onto the
power cord.
3. If 110 volt operation is desired and you are
inexperienced with wiring, contact our
Service Department for further information.
4. A wiring diagram is located on Page 31 of
this manual to further assist you with wiring
details.