Grizzly G9969 - Manual (Page 11)

G9969 Radial Drill Press
-9-
Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
110/220V Operation
SECTION 2: CIRCUIT REQUIREMENTS
Amperage Draw
The Model G9969 features 110/220V motor that
is prewired for 110V and draws the following
amps under maximum load:
Motor Draw at 110V ............................... 10 Amps
Motor Draw at 220V ................................5 Amps
Figure 2. NEMA 6-15 plug and outlet.
ALWAYS remove light
bulb if converting to
220V. If the light socket
is used while operating
at 220V, the light bulb
WILL EXPLODE, poten-
tially causing serious
personal injury.
Circuit Requirements
We recommend using a dedicated circuit for this
machine. You MUST connect your machine to a
grounded circuit that is rated for the amperage
given below. Never replace a circuit breaker on
an existing circuit with one of higher amperage
without consulting a qualified electrician to ensure
compliance with wiring codes.
If you are unsure
about the wiring codes in your area or you
plan to connect your machine to a shared cir-
cuit, consult a qualified electrician.
110V Circuit ...........................................15 Amps
220V Circuit ...........................................15 Amps
Plug Type
The Model G9969 comes prewired with a NEMA
5-15 plug. If you wish to rewire the motor to 220V
we recommend using the following plug (see
Figure 2 for an example):
220V Plug & Outlet ............................NEMA 6-15