Grizzly G9969 - Manual (Page 14)

-12-
G9969 Radial Drill Press
Inventory
After all the parts have been removed from the
crate, you should have the following items:
Box 1: (Figure 3) Qty
A. Drill Press Headstock ................................. 1
B. Headstock Bracket ..................................... 1
C. Column Cap (attached to column) ............. 1
D. Column ....................................................... 1
E. Base ........................................................... 1
Figure 3. Major inventory components.
A
B C
D
E
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any inventory items are missing.
Other Components and Hardware Qty
• Downfeed Handles ..................................... 3
• Lock Handles 1 ⁄
4
"-20 ................................... 2
• Crank Handle Arm ...................................... 1
• Crank Handle ............................................. 1
• Arbor JT#3/MT#4 ....................................... 1
• Chuck JT#3 ................................................ 1
• Chuck Key .................................................. 1
• Cover Knob 1 ⁄
4
"-20 ...................................... 1
• Phillips Head Screw 1 ⁄
4
"-20 x 1 ⁄
2
" ................. 1
• Flat Washer 1 ⁄
4
" ........................................... 1
• Drift Key ...................................................... 1
• Hex Bolts 1 ⁄
2
"-13 x 2" .................................. 4
• Flat Washers 1 ⁄
2
" ......................................... 4
• Hex Wrenches 3, 4, 5mm ...................... 1 ea
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi-
ency, replacements can be obtained at your local
hardware store.
The unpainted surfaces are coated with a waxy
oil to protect them from corrosion during ship-
ment. Remove this protective coating with a sol-
vent cleaner or citrus-based degreaser such as
Grizzly’s G7895 Degreaser. To clean thoroughly,
some parts may need to be removed.
For opti-
mum performance from your machine, make
sure you clean all moving parts or sliding
contact surfaces that are coated. Avoid chlo-
rine-based solvents, such as acetone or brake
parts cleaner, as they may damage painted sur-
faces should they come in contact. Always follow
the manufacturer’s instructions when using any
type of cleaning product.
Clean Up
Gasoline and petroleum
products have low flash
points and could cause
an explosion or fire if
used to clean machinery.
DO NOT use gasoline or
petroleum products to
clean the machinery.
Many of the solvents
commonly used to clean
machinery can be toxic
when inhaled or ingest-
ed. Lack of ventilation
while using these sol-
vents could cause seri-
ous personal health risks
or fire. Take precautions
from this hazard by only
using cleaning solvents
in a well ventilated area.