GE 25893 - Manual (Page 31)

31
An (blinking) Currently answering a call.
F (blinking) Memory is full.
Six bars (blinking) Recording a memo or announcement.
LA (Line Access) External line remote answering system.
T
ROUBLESHOOTING
G
UIDE
C
ORDLESS
P
HONE
S
OLUTIONS
No dial tone
• Check or repeat installation steps:
Make sure the base power cord is connected to a working electrical outlet.
Make sure the telephone line cord is connected to the base and the
wall jack.
• Connect another phone to the same wall jack; if it doesn’t work, the
problem might be your wiring or local service.
• The handset may be out of range of the base. Move closer to the base.
• Make sure the battery is properly charged (16 hours).
• Make sure the battery pack (in the handset) is properly installed.
• The handset should beep when you press the TALK/callback button, and
the charge/in use indicator on the base should be lit when the handset
rests in the cradle. If not, the battery many need to be charged
• Place the handset in the base for at least 20 seconds to reset the unit.
Dial tone is OK, but can’t dial out
• Make sure the TONE/PULSE setting is programmed to the type of
service you are subscribed to.
Handset does not ring
• Make sure the RINGER switch on the handset is turned to ON.
• The handset may be out of range of the base. Move closer to the base.
• You may have too many extension phones on your line. Try unplugging
some phones.
• Check for dial tone.