GE JV936 - Manual (Page 16)

The ceiling bracket must be installed when the duct
cover is used to span 24” or more height above the
hood. The bracket will hold the decorative duct cover in
place at the top.
Note:
The ceiling bracket is not required when using
only the 12” section of the duct cover.
• Install the 2 small screws into the sides of the duct
bracket. Remove the screws. Pre-tapping the holes will
insure ease of final installation.
• Match center notch on the bracket to the centerline
on the wall and flush against the ceiling.
• Mark the 2 screw hole locations.
• Drill 1/8” pilot holes in marked bracket location.
• If pilot holes do not enter studs, enlarge the holes to
3/8” and install wall fastener anchors.
• Secure the bracket to the rear wall with wood screws
and washers. Use wall anchors if needed.
Note: Bracket has 2 sets of holes. Use larger holes for wall
fasteners or wood screws with washers. Use smaller holes
for wood screws with washers.
INSTALL CEILING BRACKET
Installation Instructions
16
5
Install Ceiling
Bracket When
Duct Cover is
Used to Span
24” or more
See Step 9
to Install
Duct Cover
1 Ft = 0.3 m
1” = 2.5 cm
CONNECT DUCTWORK 6
• Push duct over the end of the transition until it
reaches the stop tabs.
• Install ductwork, making connections in direction of
airflow as illustrated.
• Secure joints in ductwork with sheetmetal screws.
• Wrap all duct joints with duct tape for an airtight seal.
• Use duct tape to seal the flange connection.
Duct Tape
Over Seam
and Screw
Duct Tape
Duct Tape
Over Flange
Screw
Duct
Stops
Air Flow
CAUTION:
Do not use sheet metal screws at the hood flange
connection. Doing so will prevent proper damper
operations. Seal connection with tape only.