GE JV936 - Manual (Page 18)

INSTALL FILTERS
Installation Instructions
11
1 Ft = 0.3 m
1” = 2.5 cm
INSTALL OPTIONAL COMMERCIAL
FILTERS
11A
• Remove supplied filters (if installed).
• Remove protective film covering the filters.
• Insert the filter into the “C” clips mounted to the top
of the vertical front panel.
• Tap the filter against one side to align with outside
opening.
• Pull the filter down into the lower slots at the bottom
of the filter support.
• To remove the filters, grasp the handle, push the filter
up and pull forward.
18
Junction
Box
“C” Clip
Filters
Filter
Support
• Place the filter drip trays into the horizontal channel
in the filter panel, located behind the filters. The
grease will drain from the filters into these trays.
• Insert the filter into the “C” clips mounted to the top
of the vertical front panel.
• Position the filter in the lower slots at the bottom of
the filter support.
• Push control knobs onto the shafts.
INSTALL CONTROL KNOBS 12
• Refer to the operating instructions to test all controls.
FINALIZE INSTALLATION 13