2 checking the engine oil level, 3 changing the engine oil, 1 engine oil recommendations – Generac 04389-1 User Manual

Page 19: 2 oil change procedure, Oil dipstick and fill, Figure 4.1 – generator control panel

Advertising
background image

Generac

®

Power Systems, Inc.

17

Figure 4.1 – Generator Control Panel

4.2

CHECKING THE ENGINE
OIL LEVEL

For oil capacities, see “Specifications,” Section 1.5
(Page 6). For engine oil recommendations, see
Section 4.3.1. To check the engine oil level, proceed
as follows (Figures 4.2 and 4.3):

1. Start the generator by moving the Auto/

Off/Manual switch to the MANUAL position. Allow
it to run for a short while and then shut it down
by moving the switch to the OFF position.

2. Remove the dipstick and wipe it dry with a

clean cloth.

3. Install the dipstick; then, remove it again. The oil

level should be at the dipstick “Full” mark. If nec-
essary, add oil to the “Full” mark only. DO NOT
FILL ABOVE THE “FULL” MARK.

Never operate the engine with the oil level
below the “Add” mark on the dipstick. Doing
this could damage the engine.

4. Install the dipstick.
5. Reset the Auto/Off/Manual switch to its original

position.

Figure 4.2 — Oil Dipstick and Fill, 7 kW

Figure 4.3 — Oil Dipstick and Fill,

12 kW and 15 kW

4.3

CHANGING THE ENGINE OIL

4.3.1 ENGINE OIL RECOMMENDATIONS

Use oil of American Petroleum Institute (API) Service
Class SG, SH or SJ. Use all season SAE 5W-30
Synthetic oil. Organic break-in oil is required before
using synthetic oil.

NOTE:

The unit is supplied with “break-in” oil. See the
“Break-in Procedure,” Section 3.1 (Page 14), for
the first required oil change.

Any attempt to crank or start the engine before
it has been properly serviced with the recom-
mended oil may result in an engine failure.

4.3.2 OIL CHANGE PROCEDURE

To change the oil, proceed as follows:

1. Run the engine until it is thoroughly warmed up

then shut OFF the engine.

2. Immediately after the engine shuts OFF, pull the

oil drain hose (Figure 4.4 on page 18) free of its
retaining clip. Remove the cap from the hose and
drain the oil into a suitable container.

3. After the oil has drained, replace the cap onto the

end of the oil drain hose. Retain the hose in the clip.

4. Refill with the proper recommended oil (see

Section 4.3.1). See Section 1.5.2 (Page 6) for oil
capacities.

‹

!

‹

Oil Dipstick

Oil Fill

Oil Dipstick and Fill

!

HIGH TEMP.

OVER SPEED

LOW OIL

SYSTEM SET

OVER CRANK

MAN.

SET

OFF

AUTO

15A

FUSE

EXERCISE

TIME

R

POWER SYSTEMS, INC.

L o c a t e y o u r

n e a r e s t

d e a le r

a t :

R

FUSE

5A

E X E R C IS E R

N O T

S E T

N O

U T IL IT Y

S E N S E

4

F L A S H IN G R E D

L E D S =

F L A S H IN G G R E E N

L E D =

Section 4 — Maintenance

Guardian Air-cooled 7 kW, 12 kW and 15 kW Generators

Advertising
This manual is related to the following products: